What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 26.06.2025 11:30
A circuit breaker is similar, but is resettable.
Because the load is inductive, the current lags the voltage.(by a bit).
I post the exact comment here.
GUNTHER wins the world heavyweight championship back from Jey Uso - Cageside Seats
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
First Sentence:
This is where the MOV conducts again, and dissipated the energy.
What is your review on the Last of Us Part 2?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
Barnstars:
The third is lightning and “how it gets conducted into a home.”
Do you think Trump is a bad a$$? Why or why not?
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
the problem then depends on "how fast does the fuse operate?".
What does it mean when someone is pretending to be me?
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
At least they know the answer if they wanted it.
He then describes the function of a fuse.
Why are Korean female leads so angry all the time?
[image of Common-mode choke]
eight
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Elden Ring Nightreign Patch Notes Include Promised Improvements For Solo Play - GameSpot
The MOV will conduct when the voltage exceeds 50% of line voltage.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
It also is a device that limits the change in current flow.
What are the top AI tools enhancing workplace productivity in 2025?
One
He then describes Rainy Season and Lightning.
so, what happens?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is where this question deviates from being a 'generic' question, and becomes more specific.
Circle IPO Is Said to Price Above Range to Raise $1.1 Billion - Bloomberg
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
[old diagram got deleted by accident]
A fuse is a non-resetable over current circuit protector.
There are two important concepts here.
These are simplified answers to the original question, and does not change anything I wrote above.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is 'the assistant's answer'
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
There are three different concepts here that are getting confused.
The other is “what does a “fuse” do?”
Upvotes:
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
An AC voltage/ current source, and an ac inductive load.
The bolt then partially travels down the line to your home.
But it can get overloaded, and no longer works.
He then asserts :
At one ohm, the resistor has a maximum of 1 watt power.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
a photo is worth a thousand words.
Here is a simplified AC power diagram.
It seems Mohan does not understand the difference between a comment and an Answer.
This device then solves the entire problem.
but this device (an Inductor) … impedes the rapid changes in the current.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
but I think this circuit , shows a few more pieces.
What is lightning?
For this case there are devices called Metal oxide varistors (MOV).
One is “what exactly is in a ‘surge protector’ ? ”
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
Can the fuse protect the electronic devices from lightning instead of a surge protector.
2024–10–10[John johnson John Johnson ]
(Dc diagram shown, AC is similar).
nine
This one hit behind the barn.
2024–10–14 [Omar Gharbi Omar Gharbi ]
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Edit 2024–10.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
So, the voltage could go up to 500 volts, and the fuse will not open up.
In schematic diagrams this is the symbol for a fuse:
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
These devices are installed between the “hot” and “neutral” and protective ground.
Now when you have a certain ac resistance, then a current flows in a loop.
But… the neutral is now “floating” because of the 1 ohm resistance.
what exactly is a ‘surge’ protector?
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–16 [ OO OLAOYE OYEBODE ]
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
What does a fuse do?